The TP-Link Extender enhance the WiFi signal at your home by receiving wireless signals from your router and re-emulating these signals using powerful antennas. They amplify the signal to increase your coverage by at least twice the range. Place the extender approximately halfway between your router and the dead zone of WiFi. The extender will collect and relay the WiFi signals from the router into adjacent areas, thereby expanding the coverage of your wireless network. Thus, you can Boost Your TP-Link Extender WiFi Signal. The devices will be able to connect to the network either through the router or extender when you move around your home. Read this blog to know more about the extender signal.
Boosting extender Signal
As with range extenders, wireless routers are also susceptible to interference from obstructions like metal objects, concrete walls, and microwaves. To eliminate these obstacles for the most efficient wireless performance. Each range extender from TP-link has an LED that indicates the strength of the signal that the range extender receives from the router connected to and can help you locate the most suitable location for the extender.
How do I verify the network status of the TP-Link extender?
You can look up the online report of your extender to verify whether you’ve successfully set up your extended network. Follow the steps to do the same.
- Firstly, log in to the Web Management page for this range extender.
- Click on the settings tab and then click on the status option to see the status of the internet on your extender.
- Suppose the extender is unable to be connected to the host network. Visit the settings and then click on wireless. After that, click Connect to Network to verify the host’s password.
- When the extender has been connected to the host network, however, it is not transmitting data; verify your router’s internet connection.
- If your extender is misconnected to the router, check the settings. Select the network, and set your extender to receive an IP address on autopilot. Choose the Internet/router/range extender/clients icon. You can view the corresponding information.
Reset process
It is possible to perform the reset on your own or router more easily. A factory reset will prepare the device to be ready for installation of a new version.
- Plug the extender into the power source. If the power light is not lit, press the power or ON/OFF buttons.
- Watch for the LEDs to turn on the extender to stop bouncing.
- Locate the extender’s reset button or the factory reset switch. It is located in the back or on the lower panel of the extender. It is behind a tiny hole.
- Use a paperclip or another similar-sized object to push the reset button for factory settings. Press the button for about 10 seconds or until the power LED turns on.
- Lastly, make sure that the LED is on and it is stable.
The extender is reset, and you can now begin the TP-Link Extender Setup procedure.
Conclusion
You can boost the WiFi Signal of the TP-Link Extender by following the above steps. Contact our experts if you encounter any problems.